Cincinnati Airsoft Forum

So I was shooting my gun today. Just sighting it in and re-adjusting the motor. Then for reasons unknown to me (hence the post), the trigger stuck in the pulled position. So then i pushed it forward and shot again, The trigger remained in the pulled position. I flipped it over to FA next, and after I let out a burst, the trigger returned back to how it was supposed to be. I tried one more time, and received the same results from shooting in semi the two times before. My gun did take a little abuse from Op Bio-shock2, but nothing that I believe would cause this. Also before this happened I was successful in putting a little over 100 rounds through it.

So then, any suggestion?

What kind of gun is it?

E1 416. So it's a v2 mechbox.

My guess is that your trigger mechanism that pushes into the contacts to complete the curcuit has popped off it's track allowing your cut-off lever to not do it's job. Your cut-off lever is what keeps your gun from firing more than one shot on semi. When you take apart your gearbox, it is the small lever that sits underneath your sector gear and goes behind the trigger rigging. When I put together my first V2 gearbox, I didn't seat it right when installing the trigger and I had the same problem that I couldn't fire semi just full auto.

Hope this helps a bit.

Have quickly answered :)